General Notes; Safety Warnings; Working Area - Nespresso AGUILA 440 Bedienungsanleitung

Safety warnings

General notes:

Risk of material damage
• This equipment is to be installed to comply with the applicable federal, state or local plumbing codes.
• Wrong handling of the machine can lead to property damage.
• This machine is designed for indoor use only. Keep it in a controlled environnement (protected from dust, moist, direct sunlight,
pests, etc.)
• Clean the machine within 24 hours of the first milk recipe preparation or before taking it out of service for an extended period of
time. Remove and empty the capsule container, disconnect the machine from the mains. Remove and empty milk container(s),
clean and store it with the lid open. Leave refrigerator door open when the machine is disconnected from the mains.
• For optimal performance, the ambient temperature must be between 16 °C and 32 °C.
• Position the machine on a flat, horizontal, stable, heat-resistant and fluid-resistant surface.
• Do not position the machine where a water jet might be used for cleaning.
• Leave a gap of at least 50 mm in front of air vents.
• Store the machine in a dust-free and dry environment, always at a temperature above 0 °C.
• The top of the machine must be at least 1.5 m above the floor.
• Place the machine 20 cm or further from the user.
• Only use Thermoplan cleaning accessories.
• Never use the machine without drip grid.
• The manufacturer does not accept any liability for consequences arising from both internal and external modifications of the
machine.
• Do not store explosive or flammable substances such as aerosol cans with a flammable propellant inside the appliance.
• Never use the cup heater for drying wet cups; risk of electric shock.
• Always place the cups upside-down to ensure good heat transmission.
SAVE THIS INSTRUCTIONS
• Pass them on to any subsequent user.
• This Instruction Manual is also available as a pdf at nespresso.com/pro
Structure
The safety instructions in this document are structured as
follows:
1 2 3 4
5
6
1 Safety sign 4 Impact
2 Safety signal word 5 Specified safety sign
3 Source 6 Prevention
Safety signal words
The following warning messages are used in this manual:
Indicates a hazardous situation
WARNING
which, if not avoided, could result
in death or serious injury.
Indicates a hazardous situation
CAUTION
which, if not avoided, could result
in minor or moderate injury.
Addresses practices that could
NOTICE
lead to property damage but not
to injury.
Hint
Addresses practices that help the reader to use the equip-
ment properly.
Safety signs
The following safety signs are used in this manual:
The warning triangle appears where nonadherence to
the safety instructions may result in risks to the user or
the machine.
Warning:
Electric shock
Warning:
Risk of scalding
Warning:
Risk of bruising
Instruction:
Wear gloves
Instruction:
Wear goggles
General information

Working area

• Keep your working area clean and tidy. Untidiness and unlit
working areas can lead to accidents.
• The machine must only be operated in a hygienic and ergo-
nomic environment. The user must have sufficient space and
the working area must be well lit.
EN
7