Toshiba SUPER-HRM MMY-MAP0802FT8 Installationshandbuch Seite 18

Change of indoor address from wired remote controller
• To change the indoor address in individual operation (Wired remote controller : Indoor unit = 1 : 1) or group control
(When the setup operation with automatic address has finished, this change is available.)
<Procedure> (Operation while air conditioner stops)
1
Push simultaneously
(The firstly displayed unit No. indicates the header indoor unit in group control.)
2
In group control, select an indoor unit No. to be changed by
(The fan of the selected indoor unit is turned on.)
3
Using the setup temp.
4
Using the timer time
change.
5
SET
Push button.
6
UNIT
Using the button, select the unit No. to be changed at the next time.
Repeat the procedure
7
After the above change, push
8
If it is acceptable, push
SET CL
TEST
+ + buttons for 4 seconds or more.
/ buttons, set
/ buttons, change the displayed setup data to a data which you want to
4 6
to and change the indoor address so that it is not duplicated.
UNIT
button to confirm the changed contents.
TEST
button to finish confirmation.
SET DATA
TEMP.
3
5
FILTER
RESET TEST
8
1
Operation procedure
® ® ®
1 2 3
UNIT
button.
13
to the item code.
CODE No.
SETTING
UNIT No.
R.C. No.
ON / OFF
TIMER SET FAN MODE
TIME SWING/FIX VENT
SET CL UNIT
® ® ®
4 5 6 7
14
4
2, 6, 7
®
8
End