Toshiba SUPER-HRM MMY-MAP0802FT8 Installationshandbuch Seite 17

7
ADDRESS SETUP
2. When you want to know position of the indoor unit using the address
• To confirm the unit numbers in a group control;
<Procedure> (Operation while the air conditioner stops)
The indoor unit numbers in a group control are successively displayed, and the corresponding indoor fan is turned on.
1
VENT TEST
Push + buttons simultaneously for 4 seconds
or more.
• Unit No is displayed.
• The fans of all the indoor units in a group control are
turned on.
2
UNIT
Every pushing
the group control are successively displayed.
• The firstly displayed unit No. on number indicates the
address of the header unit.
• Only fan of the selected indoor unit is turned on.
3
TEST
Push button to finish the procedure.
All the indoor units in group control stop.
• To confirm all the unit numbers from an arbitrary wired remote controller;
<Procedure> (Operation while the air conditioner stops)
The indoor unit No. and position in the same refrigerant line can be confirmed. An header unit is selected, the indoor
unit numbers in the same refrigerant line are successively displayed, and then its indoor unit fan is turned on.
1
Push the timer time
Firstly, the line 1, item code
2
UNIT
Using and SWING/FIX
address.
3
SET
Using button, determine the selected line address.
• The indoor address, which is connected to the
refrigerant line of the selected refrigerant line is dis-
played and the fan is turned on.
4
UNIT
Every pushing
in the same refrigerant line are successively
displayed.
• Only fan of the selected indoor unit operates.
[To select another line address]
5
CL
Push button to return to procedure
• The indoor address of another line can be successively
confirmed.
6
TEST
Push button to finish the procedure.
button, the indoor unit numbers in
TEST
+ buttons simultaneously for 4 seconds or more.
AC
(Address Change) is displayed. (Select outdoor unit.)
buttons, select the line
button, the indoor unit numbers
2
.
3
FILTER
End
RESET TEST
1
1
FILTER
RESET TEST
6
3
Operation procedure
1
4
13
CODE No.
SET DATA SETTING
UNIT No.
R.C. No.
TEMP.
ON / OFF
TIMER SET FAN MODE
TIME SWING/FIX VENT
SET CL UNIT
Operation procedure
® ®
1 2 3
End
CODE No.
SET DATA SETTING
UNIT No.
R.C. No.
TEMP. ON / OFF
TIMER SET FAN MODE
TIME SWING/FIX VENT
SET CL UNIT
® ® ®
2 3
® ®
5 6
End
1
2
2
4
5