Stocker Magma E-35 TP Benutzerhandbuch Seite 82

Pruning shears Magma E-35 TP - Pruning shears Magma E-35 TP with telescopic handle
11
Problems Causes
1. The battery is out
of power
2. The battery is
not connected
Shears will not start
3. Safety lock of the blade
cannot be unlocked
4. On/off switch failure
1. Loose internal
Intermittent operation connections
2. On/off switch failure
1. The blade is not sharp
2. There is a gap between
Hot blades blades
3. Poor lubrication, resulting
in excessive friction
162
Art. 312 / Art. 582 / Art. 583
Troubleshooting
Solutions
1. Charge the battery.
Instructions on page 147.
2. Check that the battery is inserted
correctly. When connected correctly,
it makes a „click" sound.
3./4. Send to repair service center by
local authorized reseller or Stocker Srl.
1./2. Send to repair service center
by local authorized reseller or
Stocker Srl
1. Sharpen the blade or replace it.
Instructions on how to sharpen the
blade on page 158, on how to replace
the blade on page 157.
2. Adjust the gap between the
blades. Instructions on page 158.
If the adjustment doesn't solve
the problem, replace the blade.
Instructions on how to replace the
blade on page 157.
3. Carry out the lubrication process.
Instructions on page 156.
Art. 312 / Art. 582 / Art. 583
Pruning shears Magma E-35 TP - Pruning shears Magma E-35 TP with telescopic handle
Troubleshooting
Problems Causes
1. Poor lubrication,
resulting in excessive
friction
2. The blade is dirty
3. The blade is not sharp
Poor trimming
4. Incorrect trimming
performance
tecnique
5. The battery is not fully
charged
1. The battery is not properly
placed in the charger
2. The battery charger is
not connected properly to
the power supply
The battery will not
3. The contact point of the
charge. Charger
battery or of the battery
red light flashes.
charger is dirty
4. Defective or damaged
battery or battery charger.
For assistance and service, please contact your local authorized reseller or Stocker Srl.
For further information about the product, please contact info@stockergarden.com
11
Solutions
1. Carry out the lubrication process.
Instructions on page 156.
2. Clean the blade. Instructions on page 156.
3. Sharpen the blade or replace it.
Instructions on how to sharpen the blade
on page 158, on how to replace the blade
on page 157.
4. Carefully read operating instructions
in the "Usage" section.
5. Check the battery charge level.
Instructions on page 152.
1. Check that the battery is placed
correctly. When connected correctly, it
makes a „click" sound.
2. Connect correctly.
3. Clean with a dry cloth.
4. Try to charge both batteries with
the same battery charger. If only one
works, the other battery is defective or
damaged. If none of the two batteries
gets charged, the battery charger is
defective or damaged. Contact your
local authorized reseller or Stocker Srl
for spare parts.
163