Start-Up; Inserting/Changing Batteries - ADE Nova Bedienungsanleitung

Symbols on the scales

Start-up

Inserting/changing batteries

For use, you need 2 batteries of type LR03/R03 (AAA), 1.5 V (included). The battery
compartment is located on the rear of the device.
1. Push the locking tab of the battery compartment cover towards the battery
compartment and remove the cover.
2. Insert the batteries as indicated at the bottom of the battery compartment. Pay
attention to the correct polarity (+/-).
3. Replace the battery compartment cover.
The locking tab must snap audibly into place.
Suggestions for changing the battery:
‚ A change of batteries becomes necessary when "Lo" appears on the
display, or when nothing at all is displayed.
‚ Only use the type of battery that is specified in the "Technical data".
‚ Always change all batteries at the same time.
‚ Dispose of old batteries in an environmentally appropriate way
(see "Disposal").
‚ Calibrate the scale, see "Setting up the scale".
Choosing the unit of measurement
When the scales are delivered, the unit of measurement is set to "kg" as standard.
However, the measurement result can also be displayed in the English units of
measurement, "lb" (pound) or "st:lb" (stone:pound).
− Press the UNIT button next to the battery compartment on the rear-side of the
scales repeatedly. Note the display.
BA 2103-1 | BA 2103-2 body analyser scales
The scales automatically switch on when you step onto the
weighing surface with a little force.
WARNING: When the weighing surface is damp, there is a risk of
slipping.
Start-up
21