Cleaning; Fault/Remedy - ADE Nova Bedienungsanleitung

2 kg) is found in the data stored in the scales, the LCD display flashes once and shows
the corresponding memory cell.
The body analysis will start shortly after.
However, automatic user recognition will not work if there is a weight difference of
less than 2 kg between two saved users. In this case, manual memory cell selection is
required.

Cleaning

NOTE on material damage
− Do not immerse the scale in water or other liquids.
− Never use harsh, scouring or abrasive cleaning agents or the like to
clean the scale. Otherwise, the surface could be scratched.
− Wipe the scale as needed with a slightly damp soft cloth.
− Disinfect the weighing surface and the sensors from time to time using a suitable
disinfecting agent (available at specialist retailers and pharmacies).

Fault/Remedy

Fault
No function
The scale appears to be displaying
wrong weighing results
"Err" is shown on the display
"Lo" is shown on the display
"ErrL" is shown on the display
The display shows "Errh".
BA 2103-1 | BA 2103-2 body analyser scales
Possible cause
‚ Are the batteries empty or inserted the
wrong way around?
‚ Is the scale located on a firm, even surface?
‚ Is a device that can cause electromagnetic
disturbances located in the vicinity of the
scale?
‚ Remove the battery from the scale and wait
a moment. Reinsert the battery. The data
stored up to this point will be retained.
‚ The maximum capacity of the scale (180 kg)
has been exceeded.
‚ The battery is empty (see "Changing the
battery").
‚ The fat proportion % is too low: Below 4%
nothing can be displayed
‚ The fat proportion % is too high: Above
60% nothing can be displayed.
Cleaning
27