Start-Up; Inserting/Changing Batteries - ADE BE 1723 Bedienungsanleitung

Start-up

Inserting/changing batteries

For use you require 3 batteries of type LR03 (AAA), 1.5 V (included). The battery
compartment is located on the underside of the device.
1. Push the locking tab towards the edge of the scale and remove the battery
compartment cover.
2. Insert the batteries as shown on the base of the battery compartment. Pay attention
to the correct polarity (+/-).
3. Replace the battery compartment cover. The closing flap must engage audibly.
Suggestions for changing the battery:
‚ A battery change is necessary when "Lo" or nothing at all is shown on
the display.
‚ Only use the type of battery that is specified in the "Technical Data".
‚ Always exchange all of the batteries at the same time.
‚ Dispose of the old battery in an environmentally responsible way
(see "Disposal").
‚ Calibrate the scale, see "Setting the scale".
Choosing the unit of measurement
When the scale is delivered, the unit of measurement is set to "kg" as standard.
However, the measurement result can also be displayed in the English unit "lb" (pound)
or "st lb" (stone:pound).
1. To switch on the scale, step on the middle of the weighing surface.
2. Press repeatedly the Unit button on the back of the scale.
Note the display.
Positioning the scale
1. Place the scale on an even, firm, and dry surface. Do not place the scale on carpet.
2. First, briefly step onto the middle of the weighing surface to calibrate the scale. As
soon as the display shows "0.0", calibration is complete.
This calibration must be performed after each battery change.
Bathroom Scale BE 1723
Start-up
17