Using The Cleaning Tape Cartridge (Tandberg Data Cleaning Cartridge P/N 43 18 78) - TANDBERG DLT4000 Installations-Handbuch

Tandberg Data
If ...
1. Use Cleaning Tape
indicators
(Figure 3-6)
2. A data cartridge
causes Use
Cleaning Tape to
blink
3. Use Cleaning Tape
still indicators after
you clean the drive
head
4. Use Cleaning Tape
indicators after you
load the cleaning
cartridge
3-22
Configuring and Operating the Tandberg DLT4000 Drive
3.8. Using the Cleaning Tape
Cartridge (Tandberg Data
Cleaning Cartridge P/N
43 18 78)
It means ...
The drive head needs
cleaning or the tape
is bad (see item 3)
The data cartridge
may be damaged
Your data cartridge
may be causing the
problem
Cleaning has not
been done and the
cartridge is expired
And you should ...
Use the cleaning cartridge.
Follow the instructions in
Section 3.7. for loading a
cartridge into the drive. When
cleaning completes, the Use
Cleaning Tape indicator shuts
off and the beeper sounds for
you to remove the cleaning
cartridge.
Back up this data onto another
cartridge. Discard the old car-
tridge, which may be damaged.
A damaged cartridge may
cause unnecessary use of the
cleaning cartridge.
Try another data cartridge.
Replace the cleaning cartridge.
Tandberg DLT4000 Installation Guide