Configure The Tandberg Dlt4000 Tabletop; Configuration Guidelines; Disable Parity Checking; Changing The Scsi Id - TANDBERG DLT4000 Installations-Handbuch

Tandberg Data
If you are installing the Tandberg DLT4000 as ...Then ...
The only SCSI device on the bus or one of
multiple SCSI devices on the bus
The last or only device on the SCSI bus
Tandberg DLT4000 Installation Guide
Installing and Configuring the Tandberg DLT4000 Drive
2.4. Configure the Tandberg
DLT4000 Tabletop
Topic

Configuration Guidelines

Disable Parity Checking

Changing the SCSI ID

2.4.1. Configuration Guidelines
2.4.2. Disable Parity Checking
2.4.3. Changing the SCSI ID
Section
2.4.1.
2.4.2.
2.4.3.
Be sure to use a SCSI ID that is
unique from any other device or
system ID on the SCSI bus.
You must terminate the bus by
installing a terminator on the drive.
2-5