Tandberg Data
If ...
The Density Select button is not
used
The Density Select button is
used, and if the actual tape
density is the same as the
density you selected
The Density Select button is
used, and if the actual tape
density differs from the density
selected
3-10
Configuring and Operating the Tandberg DLT4000 Drive
Then ...
The indicators show the actual density when
the tape is reading and writing. The indicators
are on steady and Density Override is off.
The actual density and the Density Override
light. For example, if the actual tape density is
10.0 GB and the selected tape density is 10.0
GB, then the indicator next to 10.0/15.0 lights.
1. The indicator with the actual density is on
steady
2. The indicator with the selected density
blinks
3. Density Override lights steady
For example, if the actual tape density is 10.0
GB and the selected density is 6.0 GB,
10.0/15.0 lights steady, 6.0 blinks, and
Density Override indicator is on steady.
Tandberg DLT4000 Installation Guide