Tape In Use - TANDBERG DLT4000 Installations-Handbuch

Tandberg Data
If ...
The yellow indicator is on
steady
The yellow indicator blinks
irregularly
The yellow indicator blinks
regularly
The green indicator turns on
and the beeper sounds
All four indicators blink
Tandberg DLT4000 Installation Guide
Configuring and Operating the Tandberg DLT4000 Drive

3.7.1. Tape in Use

It means ...
A cartridge is loaded, but the tape is not
moving. This can mean no application is
communicating with the controller, or that the
application is communicating, but is not
delivering commands for tape motion.
A calibration read or write is in progress.
The tape is loading, unloading, or rewinding.
The tape is unloaded into the cartridge and
the cartridge can now be removed, or if the
drive is unloaded, a cartridge can now be
inserted.
An error has occurred during operation. See
Table 2-4, Tandberg DLT4000
Troubleshooting Chart.
3-21