IKEA RENODLAD AA-2189640-3 Bedienungsanleitung Seite 26

ENGLISH
Problem and alarm code
The programme lasts too
long.
The remaining time in the
display increases and skips
nearly to the end of the pro‐
gramme duration.
Small leak from the appli‐
ance door.
The appliance door is difficult
to close.
The appliance door opens
during the wash cycle.
Rattling or knocking sounds
from the inside of the appli‐
ance.
The appliance trips the cir‐
cuit-beaker.
Once you have checked the appliance,
deactivate and activate the appliance. If the
problem occurs again, contact an Authorised
Service Centre.
For alarm codes not described in the table,
contact an Authorised Service Centre.
Possible cause and solution
• If the delay start option is set, cancel the delay setting or
wait for the end of the countdown.
• Activating options can increase the programme duration.
• This is not a defect. The appliance is working correctly.
• The appliance is not levelled. Loosen or tighten the ad‐
justable feet (if applicable).
• The appliance door is not centred on the tub. Adjust the
rear foot (if applicable).
• The appliance is not levelled. Loosen or tighten the ad‐
justable feet (if applicable).
• Parts of the tableware are protruding from the baskets.
• The AutoOpen is activated. This function opens the appli‐
ance door during the drying phase to improve the drying
performance and let the dishes cool down. The door re‐
mains ajar.
– The duration of the drying phase and the door open‐
ing time vary depending on the selected programme
and options.
– When the AutoOpen opens the door, the display
shows the remaining time of the running programme.
If you don't want the door to automatically open, deacti‐
vate AutoOpen. Refer to "Settings".
• The tableware is not properly arranged in the baskets. Re‐
fer to basket loading leaflet.
• Make sure that the spray arms can rotate freely.
• The amperage is insufficient to supply simultaneously all
the appliances in use. Check the socket amperage and the
capacity of the meter or turn off one of the appliances in
use.
• Internal electrical fault of the appliance. Contact an Au‐
thorised Service Centre.
Warning! We do not recommend
using the appliance until the
problem has been completely
fixed. Unplug the appliance and
do not plug it in again until you
are certain that it operates
correctly.
26