IKEA RENODLAD AA-2189640-3 Bedienungsanleitung Seite 15

ENGLISH
All the consumption values
mentioned in this section are
determined in accordance with
the currently applicable standard
in laboratory conditions with
water hardness 2.5mmol/L
according to the 2019/2022
regulation (water softener: level
3).
The pressure and the
temperature of water as well as
the variations of the mains supply
can change the values.
The rinse aid empty notification
The rinse aid helps to dry the dishes without
streaks and stains. It is automatically
released during the hot rinse phase.
When the rinse aid chamber is empty, the
rinse aid indicator is turned on notifying to
refill rinse aid. If the drying results are
satisfactory while using multi-tablets only, it
is possible to deactivate the notification for
refilling rinse aid. However, for best drying
performance, always use rinse aid.
If standard detergent or multi-tablets
without rinse aid are used, activate the
notification to keep the rinse aid refill
indicator active.
End sound
You can activate an acoustic signal that
sounds when the programme is completed.
Acoustic signals sound also when
a malfunction of the appliance
occurs. It is not possible to
deactivate these signals.
AutoOpen
AutoOpen improves the drying results with
less energy consumption. The appliance
door opens automatically during the drying
phase and remains ajar.
AutoOpen is automatically activated with all
programmes other than Rinse & Hold.
Caution! Do not try to close the
appliance door within 2 minutes
after automatic opening. This can
cause damage to the appliance.
Caution! If children, pets or
people with disabilities have
access to the appliance,
deactivate AutoOpen. The
automatic opening of the door
may pose a danger and expose
possible hazards inside the
appliance (such as knives, sharp
objects, chemicals).
Key tones
The buttons on the control panel make a
click sound when you press them. You can
deactivate this sound.
Latest programme selection
You can set the automatic selection of the
most recently used programme and options.
The latest programme that was completed
before the appliance deactivation is saved. It
is then selected automatically after you
activate the appliance.
When the latest programme selection is
disabled, the default programme is ECO.
15