Silvercrest SPU 900 A1 Bedienungsanleitung Seite 48

Should the second user be activated, the
"B" indicator appears in the display g.
6. Repeat the steps 1 - 4 (for both users) until
all desired radio stations have been saved.
AMS (Automatic Memory System)
With the AMS function the radio searches au-
tomatically for radio stations and then saves
them to the memory positions.
• Press and hold the button A.M.S. MEM-
ORY h for two seconds. The radio alarm
automatically searches for sufficiently
powerful radio stations and saves them in
the memory.
Accessing the station
1. To recall a saved radio station, in Radio
mode first select the desired user.
2. Now select the required memory page
with the PAGE/AL.SET button f.
3. Using the PRESET/ALARM +/- button s/
d, select the desired memory space for
the radio station.
Adjusting the volume.
• In radio modus, repeatedly press the but-
ton VOL — q to reduce the sound volume.
To the right in the display g the current
sound volume setting is indicated in steps
from V 0 - 18.
• Repeatedly press the button Vol. + w to
increase the sound volume.
Switch-off Timer
This appliance is fitted with a switch-off timer
for up to 90 minutes.
1. Press the button SLEEP j to call the func-
tion up and, if need be, to switch the ra-
dio on.
2. Repeatedly press the button SLEEP j to
enter in the remaining playing time in steps
of 10 minutes. After a few seconds, the
frequency is indicated once again.
3. In the display g the Sleep indicator ap-
pears .
4. At any time you can press the SLEEP
button j to blend in the remaining
countdown time for a few seconds.
All manuals and user guides at all-guides.com
5. On expiry of the time period the ap-
6. To switch the timer off prematurely,
Switching and dimming the display
You can adjust the display brightness in
three levels by pressing the SNOOZE/DIM-
MER button y. The higher the brightness,
the greater is the power consumption of the
device.
When you briefly press the MODE/LOCK
button e during radio operation, you can
toggle between frequency and time display.
Projection
The time can be projected from the appliance
onto a wall or the ceiling. This function is in-
tended for reading the time in darkness.
During the day in well lit rooms you will
hardly be able to use the projection facility.
When projection is switched on, the projection
symbol glows in the display g.
1. For this, first fold the projector t out.
2. Switch the function on with the PROJEC-
3. Direct the projector t onto the desired
4. Using the focus regulator 1( sharpen the
5. The time will now be projected onto the
6. Should you wish to switch this function off
Button lock
Press and hold the MODE/LOCK button e
until the key symbol is indicated in the dis-
play g. The normal key functions are now
blocked. The buttons retain, however, the
function "Alarm stop". In addition, the
- 46 -
pliance switches itself off.
press the l button.
TION button a.
surface area. Before you can turn the pro-
jector t - if so desired - to the side, you
must carefully pull its base up from the
device housing.
image.
desired surface area for the pre-adjusted
timespan (see section "Adjusting the Pro-
jection duration").
prematurely, press the PROJECTION but-
ton a and fold the Projector t in.