Putting The Appliance Into Use - Silvercrest SPU 900 A1 Bedienungsanleitung

1( Focus adjuster - for focussing the time
2) Wire aerial - for VHF reception
2! Power cable
2@ Battery
compartment
Putting the appliance into use
First take all appliance components from the
packaging and remove all packing foil and
tape. Check the appliance for signs of visble
damage.
Inserting the back-up batteries
With the backup batteries all individual de-
vice settings are retained in the event of a
power failure. For this you require two 1.5 V
batteries of the type AAA/Micro. They are
not supplied.
1. Open the lid of the battery compartment
2@ on the underside of the radio alarm.
2. Insert the batteries. Ensure the polarities
are correct.
3. Close the lid of the battery compartment
2@. The lid must audibly engage.
Note:
The back-up batteries must be checked
at least once per year and, if necessary,
exchanged for new ones.
Providing mains power
• Insert the plug into a mains power
socket. In the display g the welcome
"PLEASE WAIT FOR SETTING THANKS"
appears. During this period the radio
alarm attempts to update its settings
for time and date with the help of RDS
signals. Should you wish to interrupt this
process, press any button. Should the
automatic update fail, make the required
adjustments manually.
Setting the time
To programme in the time and the follow-
ing parameters, radio operation must be
switched off. If a button is not pressed within
All manuals and user guides at all-guides.com
projection
- for the backup batteries
approx. 15 seconds, the appliance saves the
adjustment and then leaves the programming
mode.
1. Press theMODE/LOCK button e. The
time display blinks.
2. Press the buttons DOWN/UP i/o to set
the time at minute intervals. Pressing and
holding down one of button changes the
time in quick succession.
Setting the date
1. Press the MODE/LOCK button e once
again. In the display g the date indica-
tion "01.01.2011" blinks.
2. Press the buttons DOWN/UP i/o to
set the date in day intervals. Pressing and
holding one of the buttons changes the
date in a fast sequence.
Programme City
1. Press the MODE/LOCK button e once
again. In the display g the indicator for
the city sign blinks below the "LOCAL
CITY" display.
2. Press the buttons DOWN/UP i/o to
programme in the time zone for a city
resp. your general place of residence.
Pressing and holding one of the buttons
changes the indicator faster. Here is an
overview of the programmable cities and
the time differences:
Abbr. Diff. City
HNL -10 Honolulu / USA
ANC -9 Anchorage / USA
YVR -8 Vancouver / Canada
LAX -8 Los Angeles / USA
DEN -7 Denver / USA
CHI -6 Chicago / USA
MEX -6 Mexico City / Mexico
NYC -5 New York / USA
YYZ -5 Toronto / Canada
YUL -5 Montreal / Canada
CCS -4 Caracas / Venezuela
RIO -3 Rio De Janeiro / Brazil
BUE -3 Buenos Aires /Argentina
- 41 -