Vibration Detection; Parking Monitoring; Auto Power Off; Screen Auto Off - Z-EDGE R1 Bedienungsanleitung

3.8 Vibration Detection

The Vibration Detection feature senses for unusual impacts or collisions detected
by the built-in G-Sensor. It automatically triggers the Emergency Video
Protection.
Set the sensitivity to automatically trigger these features with smaller or larger
vibrations (feature can also be turned Off).
G-sensor sensitive can by adjust from the: General Settings > Sensitivity > Off /
Low / Middle / High

3.9 Parking Monitoring

Enable Parking Mode feature for the dash camera to continue monitoring your
vehicle for unusual impact or collision when the engine is turned off and parked.
If a vibration is detected, the device will automatically turn on and begin
recording. Approximately 30 seconds after the motion or vibration is finished, the
device will automatically return to monitoring mode. All recordings are
automatically protected from being overwritten.
Enable/disable feature: General Settings> Motion Detection Mode > Parking
Mode> On/Off

3.10 Auto Power Off

Enable the Auto Power Off feature for the dash camera to automatically turn off
when it is not recording. This can be set to Off, 1 min, 3mins. To disable the
auto power off function set it to off.
General Settings>Auto Power Off > Off / 1 min / 3 mins.

3.11 Screen Auto Off

Enable the Screen Saver feature for the LCD display to automatically power off.
This prevents the screen from being a distraction to the driver. This feature can
be set to Off, 1 min, 3mins. The screen will automatically power off after the set
duration of time. Set the feature to Off for the screen to remain on constantly
while the device is powered.
General Settings>Screen Saver > Off / 1 min / 3 mins.

3.12 Taking a Snapshot

To take a Snapshot press the up button (9) when the dash camera is powered
on and is recording or in standby.
-13-