Default Settings; Factory Reset - Z-EDGE R1 Bedienungsanleitung

2.7 Default Settings

Menu Options
1080P+1080P, 1296P+1080P
Resolution
On/Off
Audio Recording
1min,3mins,5mins
Loop Recording
On/Off
Date Stamp
Off,1min,3mins,5mins
Device Auto Off
Off,Low,Normal,High
G-Sensor
On/Off
Logo Stamp
On/Off
Parking Mode
Off,1min,3mins,5mins
Screen Auto Off
On/Off
WDR
There are three preset scenario modes for everyday driving, scenic driving or
when the vehicle is parked. These aim to offer the optimum settings for the best
video recording in each of these instances.
You can choose to enable any one of these modes from the settings menu.
General Settings > Scenario Mode > Default / Drive / Scenic / Park

2.8 Factory Reset

To reset the dashcam to factory default
Soft Reset
1. If the device is recording, short press the 'OK' button (11) to stop recording, and
enter Standby Mode.
2. Press the 'Menu' button (8) to enter the General Settings menu.
3. Press the 'Up' and 'Down' buttons (9 & 10) to select Restore Factory Settings.
4. Press the 'OK' button (11) to select.
5. Press the 'Up' and 'Down' buttons (9 & 10) to select confirm.
6. Press the 'OK' button (11) to select.
Hard Reset
If the dash camera does not respond, you can force a factory reset using the reset
button. To reset the dashcam to the factory default settings, long-press the 'Reset'
button (1) until the dashcam's screen turns off.
Default Drive
1296P+1080P 1296P+1080P
On On
3mins 3mins
On On
1min 1min
Normal Normal
On On
Off On
3mins 1min
On On
-9-
Scenic Park
1296P+1080P 1296P+1080P
On On
5mins 1min
Off On
3mins 1min
Low High
On On
On On
Off 1min
On On