Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Manual
9.4 Disassembly of the propeller:
1. disassemble the propeller by holding the hub with tweezers or
pointed pliers and unscrew the spinner with a thin screwdriver that
fits through the hole.
9.5. centre of gravity settings
You can move the battery to set the correct centre of gravity in the cabin area.
For the beginning, the model should be slightly top-heavy. For further flights you can then adjust the centre of gravity according to your
preferences.
1. the recommended centre of gravity is 65-75mm measured from the leading edge (leading edge) of the top of the wing - with battery on
board of course!
2. on the underside of the wing you will find a „CG „ mark on each side. Balance the model here with one finger each. The model should now
nose down slightly - then the centre of gravity fits for the first flight.
www.modster.at
MODSTER Easy Trainer 1280 V2
2. Before removing the propeller from the hub, mark the propeller
(e.g. carve a cross on the surface) so that it can be re-installed later in
the correct orientation.
65-75 mm
31
Werbung
