Getting Started; Cancel The Demonstration; Set The Clock And Date; Set The Basic Settings - JVC KD-DB98BT Bedienungsanleitung

GETTING STARTED

1

Cancel the demonstration

When you turn on the power for the first time (or [FACTORY RESET] is set
to [YES]), the display shows: "CANCEL DEMO" "PRESS ENTER".
1
Press .
[YES] is selected for the initial setup.
2
Press again.
"DEMO OFF" appears.
2

Set the clock and date

1 Press and hold .
2 Press to select [CLOCK], then press
To adjust the clock
3 Press to select [CLOCK ADJUST], then press
4 Press to make the settings, then press
Hour Minute
5 Press to select [CLOCK FORMAT], then press
6 Press to select [12H] or [24H], then press
To set the date
7 Press to select [DATE SET], then press
8 Press to make the settings, then press
Day Month Year
9 Press to exit.
To return to the previous setting item, press
4
ENGLISH
3
1 Press and hold
2 Press
3 Repeat step
4 Press
To return to the previous setting item, press
SYSTEM
KEY BEEP
SOURCE SELECT
AM SRC *
BUILT-IN AUX *
F/W UPDATE
.
UPDATE SYSTEM/UPDATE DAB1/UPDATE DAB2
F/W UP xxxx/
. F/W UP xxxxx/
. F/W UP Vxxx
.
FACTORY RESET
.
* Not displayed when the corresponding source is selected.
.
.
.

Set the basic settings

.
to select an item (see the following table), then press
.
2 until the desired item is selected or activated.
to exit.
(Not applicable when 3-way crossover is selected.)
ON: Activates the keypress tone. ; OFF: Deactivates.
ON: Enables AM in source selection. ; OFF: Disables. ( 7)
ON: Enables AUX in source selection. ; OFF: Disables. ( 18)
YES: Starts upgrading the firmware. ;
NO: Cancels (upgrading is not activated).
For details on how to update the firmware, see:
<http://www.jvc.net/cs/car/>.
YES: Resets the settings to default (except the stored station). ; NO: Cancels.
.
Default: XX