Product Description - Concept CP2100 Bedienungsanleitung

EN

PRODUCT DESCRIPTION

1 Handle
2 Steam intensity button
3 Power button
4 Appliance body
5 Carpet glider
6 Water tank
7 Cleaning cloth
5
7
OPERATING INSTRUCTIONS
ASSEMBLY
Unpack all parts of the appliance and accessories.
1. Slide the handle into the main unit of the cleaner until it clicks into place (1).
2. Insert the appliance body into the floor nozzle (2).
USE
Before first use
1. Press the water tank release buttons and remove it (3).
2. Pull the water tank cap and open it.
3. Fill the water tank with distilled water. Put the cap back to the water tank. Do not add
any cleaning agents, chemicals or perfumes to the water tank.
4. Re-attach the water tank to the main part of the cleaner and make sure that the water
filter is in place.
5. Attach the textile cover on the bottom side of the floor nozzle.
IMPORTANT: Always unplug the appliance before refilling with distilled water or changing
the textile cover.
NOTE: Before use, wash the textile cover to remove any loose fibres.
46
1
2
3
4
6
CP2100 | CP2110
STEAM FLOOR CLEANING
NOTE: Before using the steam cleaner, always sweep or vacuum the floor to remove any
dirt.
IMPORTANT: Do not use the steam cleaner without the textile cover attached to the floor
nozzle.
NOTE: Do not use a carpet glider to clean the floors.
1. Plug the power cord of the appliance into the socket. Press the power button and the
blue steam intensity indicator starts to flash.
2. After a few seconds, the steam intensity indicator lights up blue, which means that the steam cleaner is ready for
use and automatically starts to produce steam.
3. After the steam heats up, use the steam intensity button to select the intensity of the steam produced: LOW for low
steam intensity, MEDIUM for medium steam intensity, HIGH for high steam intensity.
4. Step on the floor nozzle and point the main part of the steam cleaner toward the ground.
5. Move the steam cleaner slowly back and forth, paying special attention to heavy foot traffic areas.
STEAM CARPET CLEANING
NOTE: Before using the steam cleaner, always sweep or vacuum the floor to remove any dirt.
IMPORTANT: Do not use the steam cleaner without the textile cover attached to the floor nozzle.
1. Attach the carpet glider to the floor nozzle.
2. Plug the power cord of the appliance into the socket. Press the power button and the blue steam intensity indicator
starts to flash.
3. After a few seconds, the steam intensity indicator lights up blue, which means that the steam cleaner is ready for
use and automatically starts to produce steam.
4. After the steam heats up, use the steam intensity button to select the intensity of the steam produced: LOW for low
steam intensity, MEDIUM for medium steam intensity, HIGH for high steam intensity.
5. Step on the floor nozzle and point the main part of the steam cleaner toward the ground.
6. Move the steam cleaner slowly back and forth, paying special attention to heavy foot traffic areas.
CAUTION! Use only distilled water to fill the water tank!
Always unplug the appliance when filling it with distilled water, emptying it or when the appliance is not in use.
REPLACING THE WATER FILTER
The water filter helps to filter out minerals contained in water which reduce the efficiency of the steam cleaner. The
filter should be changed every 80-100 hours, depending on the frequency of the use of the appliance. Pour only
1
distilled water into the steam mop. If you live in an area with hard water, deposits of this water may form on the
heating element, which will then reduce the performance of the cleaner. After each use, remove the water tank and
pour out all the water.
ACCESSORIES
CP2100 - The package includes 1x cleaning cloth and 1x carpet glider
CP2110 - The package includes 3x cleaning cloth and 1x carpet glider
2
CP2100 | CP2110
EN
3
47