Product Description - Concept CP3000 Bedienungsanleitung

EN

PRODUCT DESCRIPTION

1 Hook for attaching a power cord
2
Lever for releasing the water tank
3
Water tank
4
Replaceable hard water filter
5
Dirt tank
6
Steam trigger
7 Power On/Off button
8 Charging indicator
9 Vacuum feature On/Off button
VAC
Steam
Bottom view
56
CP 3000
EN
10 Vacuum feature indicator
11 Steam level button (Low/High level)
12 Steam ready indicator
13 Mop pad holder
14 Microfiber mop pad
15 Power cord
16 Suction head
17 Suction inlet
18 Carpet glider
CP3000
EN
OPERATING INSTRUCTIONS
Assembly
1. Align the connector tab at the bottom of the handle
with the receiving port on top of the unit and push until
it "snaps" together.
2. Lock - Place foot on the head and gently lean the handle
back to release it for use. Return the handle to the upright
position to engage lock.
3. Power Cord Release - To loosen the cable, rotate the
hook by 45 ° and remove the cable.
4. Easy Power Cord Storage - Rotate the hook to the vertical
position, wrap the cable around the upper and the lower
hook located under the handle.
5. Carrying Handle - The handle is located on the back of
the appliance body for easy lifting, carrying and use on
stairs.
6. Microfibre Mop Pad Holder
A To attach the mop pad holder, place the head onto
the microfiber steam mop pad holder.
B To remove the mop pad holder, place foot on the
release pedal and lift the appliance.
Use
NOTE: For vacuuming, do not use the steam mop pad.
7. Press the „VAC" button to start vacuuming.
8. To empty the dirt tank, grasp the dirt tank handle, press
the release button and remove the tank.
9. Press the empty button on the front of the tank, open it
and empty it.
10. Put the dirt tank back.
NOTE: Do not use the device without the dirt tank.
CP3000
45 46
EN
VAC
STEAM
Release
button
57
CP 3000