Husqvarna 120iTK4-H Bedienungsanweisung Seite 12

2. Put the battery into the battery holder of the product.
The battery must move into the holder easily, if not, it
is not installed correctly.
3. Push the lower part of the battery and push it in fully
into the battery holder. The battery locks into position
when you hear a click.
4. Make sure that the latches lock in position correctly.
To start the product
1. Push and hold the start/stop button until the green
LED comes on.
2. Pull the power trigger lockout rearward and hold the
power trigger.
To operate the product
• Start near the ground and move the product up
along the hedge when you cut the sides.
12
• Hold the product near your body for a stable work
position.
• Make sure that the tip of the cutting equipment does
not touch the ground.
• Be careful and work slowly until all the branches are
correctly cut.
To adjust the angle of the cutting attachment
The cutting attachment can be adjusted in 7 different
positions.
1. Stop the product and remove the battery.
A
2. Hold the housing (B) tight.
3. Push and hold the lock buttons (A) at the 2 sides of
the housing (B).
4. Move the cutting attachment to the correct angle.
5. Release the lock buttons (A) at the 2 sides.
6. Move the housing (B) up and down until the cutting
attachment locks in position.
To start the SavE function
The product has a SavE function. The SavE function
gives the longest operation time from the battery.
B
1553 - 005 - 06.04.2021