Makita DMR110N Betriebsanleitung Seite 8

INSTALLATION
Installing or removing Slide battery
cartridge (Fig. 2 & 3 & 4)
CAUTION:
Always switch off the radio before removing the battery
cartridge.
● Always switch off the tool before installing or
removing of the battery cartridge.
● Hold the tool and the battery cartridge firmly when
installing or removing battery cartridge.
● To install the battery cartridge, align the tongue on
the battery cartridge with the groove in the housing
and slip it into place. Always insert it all the way until
it locks in place with a little click.
● If you can see the red indicator on the upper side of
the button, it is not locked completely. Install it fully
until the red indicator cannot be seen. If not, it may
accidentally fall out of the radio, causing injury to you
or someone around you.
● Do not use force when installing the battery cartridge.
If the cartridge does not slide in easily, it is not being
inserted correctly.
● To remove the battery cartridge, slide it from the radio
while sliding the button on the front of the cartridge or
pressing the buttons on both sides of the cartridge.
● Be careful not to pinch your fingers when opening or
closing the battery cover.
Return the battery compartment locker to the original
position.
Reduced power, distortion and a "stuttering sound" are
signs that the battery needs to be replaced.
Note:
The battery pack can't be charged via the supplied AC
power adaptor.
Installing or removing Cluster battery
cartridge (Fig. 2 & 5)
CAUTION:
Always switch off the radio before removing the battery
cartridge.
● To insert the battery cartridge, align the tongue on the
battery cartridge with the groove in the housing and
slip it into place.
● To remove the battery cartridge, take the battery out
of the terminal while pressing the buttons on the side
of cartridge.
Return the battery compartment locker to the original
position.
Reduced power, distortion and a "stuttering sound" are
signs that the battery needs to be replaced.
Note:
The battery pack can't be charged via the supplied AC
power adaptor.
Indicating the remaining battery
capacity (Fig. 6 & 7)
1. Indicator lamps
Only for slide battery cartridges with the indicator
Press the check button on the battery cartridge to
indicate the remaining battery capacity. The indicator
lamps light up for few seconds.
Indicator or lamps
Lighted
(For LXT battery cartridges only)
(For LXT battery cartridges only)
Note:
● Depending on the conditions of use and the ambient
temperature, the indication may differ slightly from
the actual capacity.
● The first (far left) indicator lamp will brink when the
battery protection system works. (For LXT battery
cartridges only)
Installing the soft bended rod antenna
(Fig. 2 & 8)
Install the soft bended rod antenna as shown in the
figure.
Note:
There is a click in the battery compartment designed to
store the removed antenna.
Using supplied AC power adaptor
(Fig. 9)
Remove the rubber protector and insert the adaptor
plug into the DC IN socket on the front side of the radio.
Plug the adaptor into a standard mains socket outlet.
Whenever the adaptor is used, the battery pack is
8 ENGLISH
2.Check button
Off Blinking
75% to 100%
malfunctioned.
Remaining
capacity
50% to 75%
25% to 50%
0% to 25%
Charge the
battery.
The battery
may have