Safety Information; Installation - EINHELL SH2000 Bedienungsanleitung

Anleitung SH 2000 SPK1 10.05.2006
Note!! The fan heater has a topple cut-out. For
this purpose a switch is installed on the bottom
of the appliance (Fig. 3 / Item 1). If this switch is
not activated the appliance will not work!

1. Safety information

Read the operating instructions before using the
appliance for the first time. The appliance may
only be used as described therein. All other
usages are not permitted.
Keep the instructions in a safe place and give
them to third parties if necessary.
Check that the appliance has been delivered in
perfect condition. If it has suffered any damage,
do not connect the appliance to the power supply.
Check the appliance, particularly the mains lead,
for signs of damage every time before use. If you
find signs of damage, contact your customer
service center.
Place the mains cable so that there is no danger
of tripping over the cable.
Do not guide the mains cable over hot parts of the
appliance during operation.
Never use the mains cable to pull the power plug
out of the socket-outlet! Never use the mains
cable to carry the appliance or try to move the
appliance by pulling the mains cable.
Never wind the mains cable around the fan
heater.
Never jam the mains cable between objects, or
pull the cable over sharp edges, or place the cable
over hot plates or open flames.
Not suitable for commercial purposes.
Use the appliance in enclosed, dry areas only.
Never open the appliance or touch live parts –
danger of fatal accident!
Never immerse the appliance in water – danger
of fatal accident!
Do not place the appliance near wet rooms or wet
areas (bathroom, shower room, swimming pool,
etc.). It must not be possible for the control
elements to be touched by a person in a shower,
a vessel filled with liquid or the bathtub.
Never use the appliance with wet hands.
Position the appliance in such a way that the
mains plug is accessible at all times.
If the appliance is not used for a lengthy period of
time, disconnect it from the mains supply.
Do not position the appliance directly below a
socket.
For supervised operation only.
If the appliance is used for a lengthy time the
housing can become very hot. Position the
8:02 Uhr Seite 5
appliance in such a way as to prevent accidental
touching.
Never position the appliance on deep pile carpets.
Do not use the appliance in rooms in which
inflammable materials (for example solvents, etc.)
or gases are used or stored.
Keep highly inflammable substances and gases
away from the appliance.
Do not use in areas where there is a fire risk (for
example wooden sheds).
Only use the radiator with its mains lead fully
extended.
Not suitable for installation on permanently
installed electrical cables.
Do not use the appliance for animal husbandry or
livestock breeding.
Do not insert any foreign objects in the appliance's
openings.
- Danger of electric shock and damage to the
appliance.
Keep children and people on medication or under
the influence of alcohol away from the appliance.
Maintenance and repair work may only be carried
out by authorized trained personnel.
Important! Do not cover the appliance – fire risk!
Pay attention to the symbol on the appliance (fig.
4).
When mounting the appliance in a bathroom, be
sure to observe the safety distances stipulated in
your country. It must not be possible for the control
elements to be touched by a person in a shower, a
vessel filled with liquid or the bathtub. In Germany
the appliance may not be mounted within
protection zone 0, 1 or 2 (in order to comply with
VDE 0100 Part 701). Please refer to the
regulations in your country.
Children or infirm persons may use the appliance
only under supervision. Children are not allowed to
use the appliance as a toy.
2. Layout (Fig. 1/2)
1 Air outlet grille
2 Indicator light
3 Thermostat control
4 Heat output switch

3. Installation

The appliance can be used indoors in a free standing
position. Keep a minimum distance of 1 m between
the housing and walls, combustible materials
(furniture, curtains, etc.). The fan heater may only be
used completely mounted and standing vertically on
GB
5