PROUSER RVC7040N Bedienungsanleitung Seite 5

B. On roof
1. Before mounting the monitor, clean the roof surface well.
2. Position the stand to the roof surface which suits your requirement.
3. Stick the double-side tape foam at the bottom of the stand. Alternatively screw in the
screws into the roof.
4. Fix the stand to the roof with offered screws.
Monitor 12V/24V connection
Please make wiring for the monitor power as follows.
1. Connect Red wire to ACC (+)
Connect Black wire to GND (-)
Connect BAT + cable to battery.
2. Connect the wireloom to the monitor.
NOTE:
Under extreme bright light conditions, the screen image may take a few seconds to
stabilize. Please wait until the images has stabilized before driving.
Occasionally, a few highlights or dark spots may occur on the LCD screen. This is a very
common phenomenon in active matrix display technology, and doesn't necessarily
indicate any defects or faults. Never try to repair this device by yourself. In case of any
problems, please turn off the display at once and notify our company or authorized
dealer. The monitor is a complex device. Any disassembly or modification may lead to
damage and void the warrantee.
High voltage is present within the monitor. The opening of the case should be by
professionals
5