PROUSER RVC7040N Bedienungsanleitung Seite 4

contact your vehicle's manufacturer for vehicle specific wiring diagrams. Alternatively
you can just look for a 12V / 24V power supply.
6. The reverse light sockets on most vehicles have two wires
connected to them. Usually the negative wire is black and the
positive wire is a coloured wire. If you are uncertain about the
wiring, you can use a 12/24 volt multimeter available at most auto
parts stores to determine which is the positive wire. Follow the
manufacturer's instructions for the safe use of the multimeter.
7. After determining which wire is the positive and which is the
negative, turn off the ignition key, then remove the battery's
negative cable.
8. Connect the GREEN wire (TRIGGER for back camera) of the
monitor wireloom to reverse light's positive(+)
9. Replace the reverse light bulb, and then re-install the light socket. Secure all the
wires with cable ties or electrical tape. This trigger cable has priority compared to
other trigger cables. When in reverse it shows always the back up camera.
10. Re-attach the negative battery cable to the battery.
11. Plug the camera to CAM-B (CAMERA BACK).
12. If LEFT/FRIGHT/FRONT cameras are optioned, please connect the trigger wire
according to above diagram. And plug the camera to each connector respectively.
Connect BROWN wire to e.g. brake trigger (+), and plug camera to CAM-F (CAMERA
FRONT)
Connect WHITE wire to e.g. left turning signal trigger (+), and plug camera to CAM-L
(CAMERA LEFT)
Connect BLUE wire to e.g. right turning signal trigger (+), and plug camera to CAM-R
(CAMERA RIGHT)
Monitor Installation
When choosing a location to mount the monitor, make sure the monitor is in an
area that will not obstruct your vision while driving.
The RVC7040N can be fixed in your vehicle on your dashboard or upside down on the
roof with the dashboard stand.
On dashboard
A. On Dashboard
1. Before mounting the monitor, clean the dashboard surface well.
2. Position the stand to the dashboard surface which suits your requirement.
3. Stick the double-side tape foam at the bottom of the stand. Alternatively screw in the
screws into the dashboard.
4. Press the stand against the dashboard surface to fix the location.
5. Snap in the monitor to the stand mounting arm.
6. Adjust the mounting arms to suit your view angle to the monitor.
On roof
4