Fan Speed - Silvercrest STVM 30 B1 Bedienungs- Und Sicherheitshinweise

˜ Assembly
Accessory needed: Cross head screwdriver
Number of persons needed for assembly: 1 adult
Fig. Step
1 . Remove the knurled screw
pole on the motor unit
C
2 . Place the pole on the base
3 . Fasten with the knurled screw
Pull off the protective sleeve from the motor
D
shaft . Discard the protective sleeve .
6 ] [
Remove the 4 lock screws
E
unit .
9 ] [
1 . Align the rear grille handle
and to the rear . Attach the rear grille
F
to the motor unit
2 . Tighten with the 4 lock screws
1 . Place the blade
Insert the pins on the motor shaft into the
G
groove on the rear of the blade .
3 ] [
2 . Tighten the lock cap
(direction of rotation:
6 ] [
10 GB/IE/NI
from the
[ 14 ]
.
9 ] [
.
[ 13 ]
.
14 ] [
from the motor
15 ] [
upwards
[ 5 ]
4 ] [
.
[ 9 ]
.
15 ] [
on the motor shaft
[ 2 ]
on the motor shaft
[ 1 ]
) .
Fig. Step
1 . Remove the lock screw and the lock
nut
17 ] [
2 . Loosen the grille clips
grille
H
3 . Centre the hanging device
grille
NOTE: The 4 grille clips
the frame of both grilles
Insert and fasten the lock screw and the lock
nut . Close the 4 grille clips
[ 17 ]
frame of both grilles
I
NOTE: The lock screw and the lock
nut
[ 17 ]
these fasteners .
˜ Tilt adjustment
.
6 ] [
Loosen the knob
Adjust the tilt angle manually .
Tighten the knob
Do not perform the tilt adjustment when the
product is in operation .
˜ Operation
Place the product on a flat, stable ground .
Connect the power plug
socket-outlet .
˜ Fan speed
Rotate the speed control knob
product on/off and to select the fan speed
setting:
Position
0
I
II
III
from the front grille
[ 18 ]
from the front
[ 16 ]
.
[ 18 ]
[ 19 ]
on the rear grille
18 ] [ 4 ] [
[ 16 ]
[ 4 ]
16 ] [
.
[ 4 ] 18 ] [
are very small . Do not lose or drop
.
12 ] [
again .
[ 12 ]
to a suitable
[ 10 ]
to turn the
[ 7 ]
Function
Off
Low fan speed
Medium fan speed
Maximum fan speed
.
of the front
.
must fit over
.
18 ] [
over the