Ce Declaration Of Conformity - FAAC E605 Bedienungsanleitung

Pagina 6 E605
Guide for the installer
1. GENERAL CHARACTERISTICS
2. TECHNICAL SPECIFICATIONS
3. PREPARATIONS
4. BOARD LAYOUT
5. CONNECTIONS AND OPERATION
5.1. CN1 TERMINAL BOARD
5.2. CN2 TERMINAL BOARD
5.3. CN3 TERMINAL BOARD
5.4. CN4 TERMINAL BOARD
5.5. CN5 TERMINAL BOARD
5.6. JP2 CONNECTOR
5.7. JP3 CONNECTOR
6. MEMORY STORING THE RADIO CODE
6.1. Memory storage of DS radio controls
6.2. Memory storage of SLH radio controls
6.3. Memory storage of LC/RC radio controls
6.4. Deletion of radio codes
7. CONTROL LEDs
8. OPERATION OF THE DISPLAY
9. OPERATING PARAMETERS
9.1. Resetting the cycle number for service request
10. PROGRAMMING
11. PROTECTIVE FUSES
12. DISPOSAL
13. OPERATING LOGICS

CE DECLARATION OF CONFORMITY

Manufacturer: FAAC S.p.A.
Address: Via Calari, 10 - 40069 - Zola Predosa - Bologna - ITALY
Declares that: Control unit mod. E605
• conforms to the essential safety requirements of the following EEC directives:
• 2006/95/EC Low Voltage directive.
• 2004/108/EC Electromagnetic Compatibility directive.
Additional information:
This product underwent a test in a typical uniform configuration (all products manufactured by FAAC S.p.A.).
Bologna, September 16, 2010
Read this installation manual to the full before you begin installing the product.
The symbol indicates notes that are important for the safety of persons and for the good condition of the automated system.
The symbol
INDEX
Notes on reading the instruction
draws your attention to the notes on the characteristics and operation of the product.
page.17
page.17
page.17
page.17
page.18
page.18
page.18
page.18
page.19
page.20
page.20
page.20
page.20
page.20
page.21
page.21
page.21
page.22
page.22
page.22
page.25
page.25
page.26
page.26
page.27
Managing Director
A. Marcellan