Display Information - auna IR-140 Bedienungsanleitung

Selecting stations
To search for a station, press on the SELECT control once, the radio will start to scan up the frequency band, and it will
stop automatically once a station has been found. Alternatively, you can also press and hold NEXT/PREVIOUS buttons
to scan up or down the frequency band. To tune manually, rotate the select control for your desired frequency.
Presets
To store a FM preset, press and hold the MEMORY button until the display shows the "Save to Preset" screen. Select
one of the 10 presets to store the current station.
To select a preset, press the MEMORY button once, then select one of the listed preset stations. When a preset station
is playing, "Pn" (P1, P2 etc...) will appear in the lower part of the display.

Display information

While the radio is playing, the frequency will be displayed, and if RDS information is available, station name and any
further RDS information such as programme name, track title and contact details can be displayed. Stereo broadcasts
are indicated with an icon at the top of the screen. To view further information about the broadcast, press the INFO
button.
Other Settings
•
Scan settings
FM scan is defaulted to stop at any available station, this would result the poor reception from weak stations. To
change the scan settings to stop only at stations with good signal strength, press the MENU button then enter into
the "Scan setting" section and select YES by the use of the SELECT control.
•
Audio settings
• The radio will automatically switch between FM stereo and mono reception, but you can override this and
switch this function manually which is helpful for poor signal reception.
• To select listening in mono, press the MENU button then enter into the "Audio setting" section and select YES
by the use of the SELECT control.
Note: During FM stereo reception, the received L/R stereo sound will be automatically combined to one single
channel to suit the single speaker design of this radio.
AUX in mode plays audio from an external audio source such as MP3 player. To play audio with Aux in mode:
• Decrease the volume level on both the radio and the audio source device.
• Connect the external audio source to the AUX IN (3.5mm) stereo socket.
• Either press MODE until the display shows "AUX in" or select "AUX in" in the main menu by the use of the SELECT
control.
• Set the desired volume on the radio and the external audio device if necessary.
Note: To further enhance energy saving, unit will go into standby mode after about 15 minutes from Aux in mode if
without signal input .
Alarms
There are two wake-up alarms with snooze function and one sleep function to turn the radio off after a set period. Each
alarm can be set to start in a particular mode. To set or change an alarm:
• Select either Alarm 1 or 2 in the main menu or press the ALARM button on the remote control.
• Select the Alarm number (1 or 2) and set the following parameters:
AUX in
Alarms & Sleep Timer
23