Button Function - auna IR-140 Bedienungsanleitung

Remote Sensor
To operate the unit with the remote control, point the remote at the Remote Sensor on the front of the main unit and
press the appropriate button. The remote control has an effective operating range of approximately 20 feet and an
angle of no more than 30°.
NOTE: Bright sunlight may interfere with the operation of the remote control.
Exchanging The Battery
• Press the battery compartment gently ac-
cording to the direction indicated in the
illustration.
• Slide to open the battery compartment.
• Insert the supplied CR2032 battery into
the compartment according to the polari-
ty markings („+" and „-") inside the com-
partment and on the battery. Replace the
battery compartment until it clicks.
Battery Precautions
• Warning -Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type.
• Use only the size and type of battery specified.
• Be sure to follow the correct polarity when installing the battery as indicated in the Battery Compartment. A rever-
sed battery may cause damage to the device.
• If the device is not to be used for a long period of time, remove the battery to prevent damage or injury from pos-
sible battery leakage.
• Do not try to recharge a battery not intended to be recharged; it can overheat and rupture. (Follow battery
manufacturer's directions.)
• Battery shall not be exposed to excessive heat such as sunshine, fire or the like.

Button Function

Press to turn on or back to standby mode(showing clock and date).
MODE Press to cycle through the modes: Internet radio, Music player, DAB radio, FM radio, Aux in.
Press to view more information about the station or track playing. Press again to cycle through
INFO
further information screens then return to the normal Now playing screen.
MENU Press to show menu for the current mode. Press again to show Now playing screen.
Press to return to previous screen. In play mode, this button may be used to return to the last
BACK
track list or station list.
Press to enter alarm wizard, turn off alarm(when alarm is sounding) and toggles between alarms
ALARM
in standby.
Summary of Controls (Unit & RC)
16