Recycling; Lifting And Transporting With Separate Devices - Zipper Maschinen ZI-RPE60C Betriebsanleitung

separate devices
There are two persons required to lift and park the machine on another transporting devices.
- one person to operate the hoist and one person to keep the machine in balance.
1. When transporting over long distances, fold the handle forward as far as possible.
2. Ensure that the lifting equipment, incl. accessories, is suitable for loads greater than 90 kg.
3. Before lifting, check the weld on the lifting ring and the fixing of the lifting frame.
4. First lift the machine only a few centimetres to check the load capacity.
5. Then lift the machine as gently as possible into the desired position.
6. Secure the load properly for transport.
19 STORAGE
If the machine is not used for a longer period of time (>30 days):
1. Empty the oil tanks or fuel tank.
2. Remove the spark plug and pour a few drops of engine oil into the cylinder. Using a
rope starter, turn the engine a few times so that the oil is well distributed inside the
cylinder. Clean the spark plug and replace it.
3. Cover the cooled machine and store it out of the reach of children and unauthorised
persons in a well-ventilated, dry and frost-free environment.
20

RECYCLING

Do not dispose of your machine in residual waste. Contact your local authorities for
information on available disposal options. If you buy a new vibratory plate or equivalent
from your dealer, he is obliged in certain countries to dispose of your old machine properly.
21 TROUBLESHOOTING
Hot surfaces and rotating machine parts while the engine is running can cause
serious injury or even death. Always stop the machine before carrying out
troubleshooting work and secure it against unintentional restarting.
Fault
Motor does not start
Motor stops
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-RPE60C & ZI-RPE90C37
1. Release the transport wheels from the rubber holder and support the
wheel axle on the ground.
2. Pull the machine backwards until the base plate rests on the rubber
supports of the wheel suspension.
3. Press the handle vertically until the centre of gravity of
Move the machine only on level and firm ground.
N O T I C E
W A R N I N G
Check O

Check fuel supply.

Check engine oil level (a sensor prevents starting if oil level is too

low).
Make sure that the spark plug ignition cable is connected.

Check spark plug

Check carburettor and air filter and make sure they are clean.

Check fuel supply.

Check that the fuel tap is open.

Check oil levels.

Lifting and transporting with
Possible cause / remedy
/O switch and make sure it is positioned to "O
N FF
STORAGE
".
N
37