Pairing With The Cyclocomputer - Pioneer SGY-PM900H90 Benutzerhandbuch

Pairing with the Cyclocomputer

EN
This section describes how to pair the installed SGX-PM900 pedaling
monitor sensors on your bicycle to the SGX-CA900 Cyclocomputer.
● This pairing procedure may be different if you are using a cyclocomputer other
than the Pioneer SGX-CA900. Please refer to your cyclocomputer's owner
manual for sensor pairing.
1. Check the sensor modes.
Check that the right transmitter and the
left transmitter are in "Pedaling mode."
• See page 8 to switch the modes.
2. Tap the [Sensors] icon in the
home screen of the SGX-CA900.
The sensor list screen opens.
3. Rotate the bicycle's crank
set one rotation to start the
transmitter.
• Pair with the Cyclocomputer within
5 minutes after the transmitters are
activated.
10
4. Tap [Connect New] in the
sensor list screen of the
SGX-CA900.
The sensor connection menu opens.
5. Tap [Device Type] and then
[Pedaling Monitor R].
• For the left transmitter, tap [Pedaling
Monitor L].
• If multiple sensors are activated,
bring the main unit closer to the
sensor, or specify the device number
to pair the sensor you want to pair.
Refer to the User's Guide of the
Cyclocomputer SGX-CA900
regarding how to specify a device
number to pair a sensor.
6. Tap [Search].
The search for the sensor starts.
A [Searching. Please wait.] message
appears.