Pairing With The Cyclocomputer - Pioneer SGY-PM910H Benutzerhandbuch

Pairing with the Cyclocomputer

EN
This section describes how to pair the installed SGY-PM910H pedaling
monitor sensors on your bicycle to the SGX-CA500 Cyclocomputer.
●
This pairing procedure may be different if you are using a cyclocomputer other
than the Pioneer SGX-CA500/CA900. Please refer to your cyclocomputer's
owner manual for sensor pairing.
1.
Check the sensor modes.
Check that the right transmitter and the
left transmitter are in "Pedaling monitor
mode."
• See page 10 to switch the modes.
2.
Tap the [Sensors] icon in the
home screen of the SGX-CA500.
The sensor list screen opens.
3.
Rotate the bicycle's crank
set more than three rotations
to start the left and right
transmitters.
12
• After the transmitters are activated, it
may take more than 1 minute to pair
with the Cyclocomputer.
• Pair with the Cyclocomputer within
5 minutes after the transmitters are
activated.
4.
Tap [Connect New] in the
sensor list screen of the
SGX-CA500.
The sensor connection menu opens.
5.
Tap [Device Type] and then
[Pedaling Monitor R].
• For the left transmitter, tap [Pedaling
Monitor L].
• If multiple sensors are activated,
bring the main unit closer to the
sensor, or specify the device number
to pair the sensor you want to pair.
Refer to the User's Guide of the
Cyclocomputer SGX-CA500
regarding how to specify a device
number to pair a sensor.