Pioneer SGY-PM900H90 Benutzerhandbuch Seite 11

7. Check the information about
the sensor.
Information about the sensors appears
when the sensors are found.
Check the following items.
• [Device Number]
Make sure that the device number
is the same as the device number
of the transmitter.
• [Error Rate]
Make sure that "OK" is displayed.
• Refer to the User's Guide regarding
the device numbers of the
transmitters.
• If the numbers that are displayed on
[Device Number] are different from
the transmitter device numbers,
specify the device numbers to pair
with the sensor.
Refer to the User's Guide of the
Cyclocomputer SGX-CA900
regarding how to specify a device
number to pair a sensor.
Pairing with the Cyclocomputer
• If "NG" is displayed in the [Error
Rate] area, the information from the
sensor is not being received correctly
because transmission conditions are
bad. Make sure that the sensor you
are pairing is activated, then bring
the SGX-CA900 closer to the sensor
and perform the pairing operation
again.
• You may not pair with the sensor
due to the influence of the 2.4 GHz
frequency band. If "NG" is displayed
even if the SGX-CA900 is moved
closer to the sensor and paired with
it, try again someplace where there
is no interference from microwaves,
radio waves, or wireless equipment.
Pairing of the right transmitter is
completed.
Then, pair the left transmitter.
EN
11