Heatscope VISION 3200 Original Montage- Und Gebrauchsanleitung Seite 50

M U N I C H H O M E S Y S T E M S
expires for all heaters, which are not installed according to this operation and installation manual!
Other protective measures may need to be taken in accordance with local fire safety regulations, e.g.
for installation on cumbustible surfaces.
All cables must be positioned so that they cannot come into contact with the radiant heater at any
time. The radiant heater must not be installed directly below a power socket. The sides of the HEAT-
SCOPE® must be at least 20 cm from any power sockets.
care, maintenance and service
EN
Before cleaning and maintaining your HEATSCOPE®, disconnect it from the power supply or, if buried
cables are used, switch it off via the omnipolar switch. Ensure that the unit has cooled down – wait at
least 30 minutes after the last use before you start cleaning it.
All surfaces should be cleaned using a damp cloth only. Never use cleaning products containing alkali-
ne substances such as sodium hydroxide or soap, surfactants or solvents such as alcohol.
Use only a very soft cloth or a brush for the reflector and the heating elements.
Removal from service / disposal
When the unit reaches the end of its life, it must be removed from service by a specialist in accordance
with the relevant regulations and steps must be taken to ensure that it cannot be put into use again.
The unit must be disposed of professionally and in an environmentally friendly manner. The relevant
legal regulations must be observed.
Guarantee and warranty
The HEATSCOPE® is guaranteed for 24 months. The warranty period begins on the date on which the
new unit was purchased. Expendable parts or defects that affect the usability of the unit only slightly
are not covered by the guarantee. When making a guarantee claim, you must provide the original
invoice showing the date of purchase and the unit model.
Processing of guarantee claims
Please contact your dealer/distributor before returning the defective unit along with valid proof
of purchase and a detailed description of the fault. Please note: Don't send in any devices to the
manufacturer without any former contact with your distributor or dealer. He will inform you about all
follwoing steps. The manufacturer will only accept the unit, if it is returned with adequate transport
packaging which protects it securely during transport.
The manufacturer will, at its own discretion, fulfil its warranty obligations by either repairing or ex-
changing the faulty unit or individual parts of the faulty unit. If a unit is replaced, the shape and colour
of the new unit may vary slightly from the original one. The original date of purchase shall determine
MHS Munich Home Systems GmbH · Kramergasse 32 · 82054 Sauerlach · Germany