Slave Mode; Light - Switch / Dimming / Standby Values - Niko SWISS GARDE 300 Applikationsbeschreibung

3.1.1. Slave Mode

Slave Mode
LED green
Value of object
Idle time after switch off
Cyclical transmission
PIR evaluation
Active sensors
Sensitivity setting

3.2. Light - Switch / Dimming / Standby values

Operating mode of the detector
Green LED
Delay time
Brightness below which sensor is active
Brightness above which lighting is turned
off
Forced control object or disabled object
2524X_2525XCH_ETS_description
The slave mode can be reached in the menu General: click the type of detector as slave and the menu slave mode appears. The delay time of the slave unit is fixed to
30 sec..
For testing purposes, the indication LED for motions can be activated.
Selectable ON or OFF
Can be set from 1 sec to 60 sec
Default value is 5 sec
We recommend retriggering the Master unit cyclically when operating in the Master/Slave mode.
The interval time for cyclical transmission can be set from 1 second to 4 hours.
Default value is 30 sec
The 3 PIR sensors can be enabled individually or in groups. The numbers 1, 2, and 3 correspond to positions 1, 2, and 3 as shown in the illustration (§3.6).
The sensitivity can be adjusted from 1 to 10.( 1 = min, 10 = max)
The default value is 5.
Sets the operating mode to fully or semi-automatic.
This LED may flash once after each motion detection or remain off
The delay time for the light channel can be set from 1 sec to 4 hrs
Set lighting value from 10 Lux to 2000 Lux and always.
Important: If the light channel always remain active ( even with values > 2000 lux,the parameter must be to always.
Brightness threshold (lux) for immediate switch-off, even if delay time has not yet elapsed. Default value is OFF.
This will set object 3. See description of object 3: force control mode – lock mode (§3.6)
2524X/2525XCH
5
EN