Installation Instructions; Attaching The Wall Mounting Bracket; Wall Mounting The Convector - AEG WKL 502 Gebrauchs- Und Montageanweisung

2. Installation instructions

ATTENTION!
The installation, electrical connection and first operation of this appliance should be carried out by a
qualified installer.
The company does not accept liability for failure of any goods supplied which have not been installed
and operated in accordance with the manufacturer's instructions.
This convector heater must be installed by an authorised serviceman in conjunction with these instructions.
These installation instructions belong to the heater and must be handed on to the successor if the heater is
sold.
AEG convector heaters are direct electric heaters designed to be mounted on the wall and are particularly
suitable for heating smaller rooms such as utility rooms, kitchen, bath- and washrooms etc.
The convector heater is supplied with a lead.
(Exception: WKL502 C to WKL3002 C)
The convector heater must not be mounted immediately
below a wall socket.
During the just operation, the heater may give off a smell.
Ensure that the room is ventilated (for example, open a
window).

2.1 Attaching the wall mounting bracket

The wall mounting bracket is oriented centrally
(see figure and the following table).
Use the wall-mounting bracket as a template for positioning the heater correctly and providing the correct
distance from the floor.
Place the bracket on the floor. Mark the screw-holes through the drill holes ( ).
Type
Connecting power
Breadth
Heigth
Depth
with wall mounting
Measure A
Weight
Raise the bracket and position it in such a way that holes B
are aligned with the marks on the wall you have just made.
Now mark the upper holes through holes C and D in the wall
mounting ( II ).
Drill the four holes, insert plugs and screw the wall mounting
securely to the wall using four screws.

2.2 Wall mounting the convector

On the backside of the convector there are 4 slots, these
should be hooked onto the wall bracket and pushed down.
The spring clips should be turned clockwise to secure.
To remove the convector reverse the above operation.
WKL WKL
502 752
W 500 750
mm 370 370
mm 450 450
mm 78 78
100 100
121 121
kg 4.1 4.1
WKL WKL WKL
1002 1502 2002
1000 1500 2000
445 590 740
450 450 450
78 78 78
100 100 100
195 343 491
4.7 6.1 7.4
For the Professional
WKL WKL
2502 3002
2500 3000
890 1036
450 450
78 78
100 100
639 790
8.1 10.0
7