Troubleshooting - Femi GOLD Gebrauchsanleitungen Und Wartung

6.2 ASSISTENCE
When in need of skilled personnel for special maintenance,
or for repairs, both during and following the guarantee period,
always apply to authorized centres for assistance or directly
to the manufacturer if there is no authorized centre in your
area.
7

TROUBLESHOOTING

PROBLEMS
The motor does not run
The motor starts slowly and does not
reach running speed
Excessive motor noise
The motor does not reach full power
The motor tends to overheat
The saw creaks at startup
Decrease in cutting capacity
The cutting finish is irregular or uneven
Flaking of the workpiece
16
6.3
At the end of the machine life, if the machine
must be scraped, contact an authorised
waste disposal centre in order to comply with
the Standards for hygiene and environment
safeguard.
The packing must be disposed of according
to the ruling standards by delivering it to
authorised people for the collection, disposal
or reclaim.
Please contact the ASSOCIATION OF USED OILS near to
you.
CAUSES
Faulty motor, power supply cable or
plug.
Burned out fuses
Low power supply voltage. Damaged
windings. Burned out capacitor
Damaged windings. Faulty motor
Overloaded circuit due to lighting,
utilities or other motors
Overloaded motor. Insufficient motor
cooling
The drive belt is not taut enought orn
worn out.
The blade has been repeatedly
sharpened and its diameter has
decreased
The blade is worn out or the teeth are
not suited to the thickness of the
material being cut
The blade's teeth are not suited to the
workpiece
DISPOSAL OF THE MACHINE, PACKING
SOLUTIONS SUGGESTED
Have the machine checked by skilled
personnel.
Do not try to repair the machine yourselves
as it may be dangerous.
Check the fuses and replace them if
necessary.
Ask for the Electricity Board to check the
voltage available.
Have the machine motor checked by
skilled personnel.
Have the capacitor replaced by skilled
personnel.
Have the motor checked by skilled
personnel
Do not use other utilities or motors on the
circuit to which the cutting-off machine is
connected
Avoid overloading the motor during cutting.
Remove dust from the motor in order to
allow adequate cooling.
Have the belt checked by authorized
personnel.
Adjust the limit switch for the lowering of
the head
Have the blade sharpened by skilled
personnel.
Check that the blade being used is
appropriate by refering to the paragraph
'SELECTION OF THE BLADE'.
Check the appropriate teeth to use by
refering to the paragraph 'SELECTION OF
THE BLADE'
2002/96/EC