Emergency Lowering - Okay Rolf Bedienunsanleitung


Ensure that the engine frame has a uniform distan- ce to the bed frame.

Check the specifica- tions to match those of your home (operating
voltage).

The wires must be

routed so that damage is avoided. Unplug immediate- ly if a wire is
damaged.

The motor frame is designed only to a change in position with a lying
person. Please do not sit or stand on the ends of the bed.
Installation instructions for engine swap:

If the engine is not in the correct position for the installation, connect the
plug and press the button 6 (T3) or 4 (T3-ECO) on the hand switch. The motor
will move into position for installation.

For security reasons again pull the plug from the socket. For an easy
installation, place the bed frame upside down so the steel pipes face upwards.
Now firmly press the engine through the nail-shaped projections until the tubes
remain in the "u" form gap.

Make sure the symbol for the back on the engine shows to the head of the
bed frame. At the T3/

T3-ECO the holes in the top of the engine are closed on the tubes with
sliding covers, which fit into the center of the slot.

After completing the installation, check that the remote cable is properly
plugged in and is strain-re- lieved. Now place the slatted frame on the bed frame
and connect the plug, so the internal energy storage can recharge itself.

Then place the battery.

Emergency lowering:

• So you can leave the slatted frame in a reclining po- sition at
power failure, the bed has special equipment connected to an
integrated of 9-V alkaline battery,
• which is automatically activated when pressing the
• button 2 or 4 or 6. The download speed is reduced. Although the
battery can hold several emergency descents, we recommend
changing after each descent, or after a maximum of three years,
due to the deterioration of the same.