Care And Maintenance - SmartGyro AVANZA M10 Bedienungsanleitung

User manual
IX. CARE AND MAINTENANCE
Your SmartGyro Avanza requires a minimum amount of care and maintenance.
EXTERIOR SURFACES
Bumpers, tires and molding can benefit from the occasional application of a rubber or vinyl
conditioner.
Do not use a rubber or vinyl conditioner on the seat or tire tread
of SmartGyro Avanza.
CLEANING AND DISINFECTION
Use a damp cloth and a mild non-abrasive cleaner to clean the plastic and metal parts of
your SmartGyro Avanza. Avoid using products that may scratch the surface of your Smart-
Gyro Avanza.
If necessary, clean your product with an approved disinfectant. Make sure the disinfectant
is safe before application.
WARNING! Follow all safety instructions for the proper use of the disinfectant and / or
cleaning agent before applying it to your product. Failure to follow the instructions may
cause skin irritation or premature deterioration of the upholstery and / or SmartGyro Avanza
finishes.
CONNECTIONS OF THE BATTERY TERMINALS
Make sure terminal connections remain tight and not corroded.
CABLING
Check all wiring connections regularly.
Regularly inspect all wiring insulation, including the charger power cord, for wear or damage.
Have your authorized service provider repair or replace any damaged connector, connection
or insulation you find before using your SmartGyro Avanza again.
Although the SmartGyro Avanza has passed the necessary test
requirements for liquid spills, it must keep electrical connections away
from sources of moisture, including direct exposure to water or liquids.
Check electrical components frequently for signs of corrosion and
replace as necessary.
64
ABS PLASTIC COVERS
The protective parts are made of durable ABS plastic and are coated with an advanced
formula urethane paint.
AXLES BEARINGS AND THE MOTOR ASSEMBLY
All these elements are pre-lubricated, sealed and do not require subsequent lubricants.
CONSOLE, CHARGER AND ELECTRONICS
Keep these areas free of moisture.
Allow these areas to dry completely if they have been exposed to moisture before operating
your SmartGyro Avanza again.
STORING YOUR SMARTGYRO AVANZA
If you plan not to use your smartGyro Avanza for an extended period of time, it is better:
1. Fully charge your batteries before storing them.
2. Remove the smartGyro Avanza battery.
3. Store your SmartGyro Avanza in a warm and dry environment.
4. Avoid storing your smartGyro Advance to extreme temperatures.
Batteries that discharge regularly and deep, that are infrequently charged at extreme tem-
peratures or stored without a full charge can be permanently damaged, which can cause
unreliable performance and limited life. It is recommended that you charge the batteries
SmartGyro Avanza periodically during periods of prolonged storage to ensure adequate
performance.
WARNING! Protect the batteries from cold temperatures and never charge a frozen battery.
For extended storage, you can place several boards under the frame of your SmartGyro
Avanza to lift it off the ground. This removes the weight of the tires and reduces the possibi-
lity of flat spots developing in the areas of the tires that come into contact with the ground.
TERMS OF THE WARRANTY
If you have any problems with this product, we recommend that you first read this manual in
detail or go to our website smartgyro.es where you can access "Frequently asked questions
about the product", "Troubleshooting", "Manuals", etc ...
If still the problem persists, and before any procedure that you deem necessary, contact
the distributor where you purchased the product, always presenting the original purchase
invoice.
65
smartgyro.es