Operation; Switching On/Off And Adjusting Temperature; Switching Off Automatically - Silvercrest SHGBP 58 B3 Bedienungsanleitung

5. Operation

DANGER! Fire hazard!
Never cover the device or place it on
soft objects (e.g. towels). As long as the
device is switched on and/or hot, al-
ways place it on a stable, flat, heat-re-
sistant surface.
DANGER! Risk of injury
through burning!
Never touch the hot brush insert with
ceramic coating 1.
NOTE: Before using it for the first time,
switch the device on for a few minutes and
set it to the highest temperature (200 °C). As
a result of the manufacturing process, you
may notice a slight odour. This is normal and
only occurs during first use. Ensure that the
room is well ventilated.
5.1 Switching on/off and
adjusting temperature
1. Place the device on a heat-resistant sur-
face.
2. Connect the mains plug 6 to a properly
installed and easily accessible wall
socket whose voltage corresponds to
the specifications on the rating plate.
The wall socket must continue to be eas-
ily accessible after the device is
plugged in.
3. Press the on/off button
prox. 2 seconds to switch the device
on. The display 2 shows:
- 160: if prior to switching the device
on, the mains plug was disconnect-
ed.
- The value set last if the mains plug
had not been disconnected after the
device was switched off last.
6
GB
4. Pressing the +/– 3 buttons, set the de-
NOTE: decreasing bar segments indicate
that the device is cooling down. Wait un-
til the desired temperature appears on the
display before straightening your hair.
5. In order to avoid changing the tempera-
6. Press the on/off button
7. Allow the device to cool down on the

Switching off automatically

If you do not press a button on the switched-
on device for 30 minutes, it will switch off
automatically. Before this happens, the tem-
perature display will flash in the display 2.
Press the on/off button
2 seconds to switch the device back on.
4 for ap-
sired temperature between 100 °C and
200 °C using 20 °C increments. Short-
ly after, increasing bar segments on the
display 2 indicate that the device is
heating up.
ture by accidentally pressing the +/-
buttons 3, these buttons are locked au-
tomatically a few seconds after being
pressed last.
- The display 2 shows
are locked
- To unlock: press one of the +/- 3
buttons for approx. 2 seconds. The
buttons are now unlocked. The dis-
play 2 stops showing
prox. 2 seconds to switch the device
off.
heat-resistant surface.
if the buttons
.
4 for ap-
4 for approx.