Sauter OFL3.0 Betriebsanleitung Seite 43

8.1.2 Method 2 - Cutting out without template
1) Mark a rectangle for the insert plate 307 x 230 mm. The cutout is thus 1 mm
larger, allowing a better fit of the insert plate.
2) Mark a second rectangle 15 mm smaller inside the first rectangle to allow for the
supporting rebate
3) Rout out the smaller the rectangle completely from the router table top
For thicker panels, perform the milling in several steps.
4) Set the depth of the milling cutter to 9.3 mm and rout the rebate for the insert plate
5) Check that the rebate is deep enough. The insertion plate must be slightly below the
table top level.
8.2 Inserting the OFL3.0 into the milling table
Now insert the router lift and motor into the recess of the router table , unplug the
power cord first and then carefully lower the lift into the recess. fix the lift to the table
using the 4 screws provided.
! WARNING
Make sure that the power cable of your routing motor is free before the lift is fixed.
! WARNING
When constructing the milling table, make sure that it is stable and that the
necessary safety measures have been ensured . It is recommended that DIN EN
60745-2 be applied.
16