Installation; Installation Conditions; Installation Instructions - Endress+Hauser RSG30 Ecograph T Kurzbedienungsanleitung

Installation

3 Installation
3.1

Installation conditions

Working temperature range:
0 to 50 °C (32 to 122 °F), max. 75% rel.
humidity without condensation.
"
Caution!
• To avoid heat accumulation, please always ensure that the device is sufficiently cooled.
• Observe distance from strong magnetic fields.
• Environment at front in accordance with device ingress protection IP 54.
3.2

Installation instructions

3.2.1 Mounting tool
To install the control panel, all you need is a screwdriver.
3.2.2 Panel mounting, installation dimensions
Make a panel cutout, 138
DIN 43700). The installation depth of the device is approx. 170.5 mm (6.71 in) with terminals
and fastening clips.
1. Push the device through the panel cutout from the front. To avoid heat accumulation, we
recommend keeping a distance of > 15 mm (> 0.59 in) from the walls and other devices.
2. Hold the device level and then hang jack screws in the openings (2 x top, 2 x bottom).
3. Tighten the screws on the jack screws equally with a screwdriver, such that a secure seal
to the control panel is guaranteed.
!
Note!
A distance of min. 15 mm (> 0.59 in) between the devices has to be observed if aligning the
devices in the Y-direction (see Fig. 1, vertically above one another).
The devices can be arranged horizontally beside one another in the X direction (see Fig. 1) with-
out any spacing between the devices.
18
+1 +1
+0.04
x 138 mm (5.43
+0.04
x 5.43 inch) in size (in accordance with
Multi Channel Recorder