Wall-Mounted Installation - Carrier 18K Installationshandbuch

8. Remove the side board and the grille.
Hanging
Hanging arm
screw bolt
9. Mount the indoor unit onto the hanging screw bolts
with a block.
Position the indoor unit on a flat level by using a
level to prevent leaks.
Shockproof cushion
Washer
Hanging screw bolt
NOTE: Conrm the minimum drain tilt is 1/100 or more.
Ceiling Installation
D. Refrigerant pipe connection
(D.gas side)
E. Refrigerant pipe
connection
(E. Liquid side)
Drain point
Downward slope between(1-2)/100
Page 08-GB
Side board
Screw nut
Overhang part
How to install the conduit installation plate (if supplied)
1. Fix the sheath connector (not supply) on the wire
hole of the conduit installation plate.
2. Fix the the conduit installation plate on the chassis
of the unit.
Chassis
Cord conduit
The conduit
installation plate

Wall-Mounted Installation

How to install the conduit installation plate
(if supplied)
1. Fix the sheath connector (not supply) on the wire
hole of the conduit installation plate.
2. Fix the conduit installation plate on the electric
control box.
The electric control box
The conduit installation plate
The conduit
installation plate
screws (not supply)
screws (not
supply)