Special Accessories; Operation - HANSGROHE AXOR Starck 10120000 Montageanleitung

Attention! The fitting must be installed, flushed and
tested after the valid norms.
Assembly
1. Flush through the supply pipes.
2. Place the mixer including the sealing washer in
position on the basin.
3. Slip the fixation piece including the washer over
the threaded pins and tighten the nuts.
4. Connect the supply pipes to the angle valves;
cold right - hot left.
5. 10120000: Connect the pull rod to the pop-up
waste.
The hot and cold supplies must be of equal pressures.
Technical Data
This mixer series-produced with water-
dimmer (flow limiter)
®
Rate of flow with waterdimmer:
Rate of flow without waterdimmer: 14l/min 0,3 MPa
Operating pressure:
Recommended operating pressure: 0,1 - 0,5 MPa
Test pressure:
(1 MPa = 10 bars = 147 PSI)
Hot water temperature:
Recommended hot water temp.: 65° C
Hansgrohe single lever mixers can be used toge-
ther with hydraulically and thermically controlled
continuous flow heaters if the flow pressure is at
least 0,15 MPa.

Operation

open
6
English
7 l/min 0,3 MPa
max. 1 MPa
1,6 MPa
max. 80° C
close
If the continuous flow heater makes any problems or
there comes not enough water, the flow limiter (5a)
located behind the mousseur must be removed.
Spare parts (see page 3)
1 flange
2 handle Starck
3 cartridge cpl.
4 nut
5 aerator cpl.
6 pull rod
7 connection hose
8 fixation cpl.
9 extension hose 300 mm
10 lever arm cpl. 340 mm

Special accessories

X special tool set
(order as an extra )
cold
97155000
10092000
96339000
97157000
94005000
97158000
96316000
13961000
13098000
96324000
58085000
hot