Operation; Spare Parts; Special Accessories - HANSGROHE AXOR Carlton 17010 serie Montageanleitung

Assembly
1. Flush through the supply pipes.
2. Place the mixer including the sealing washer in
position on the basin / bidet.
3. Slip the fixation piece including the washer over
the threaded pin and tighten the nut.
4. Connect the supply pipes to the angle valves;
cold right - hot left.
5. 17010XXX/17015XXX/17210XXX:
Connect the pull rod to the pop-up waste.
Large differences in pressure between the hot and cold
water supply should be balanced.

Operation

The mixer is actuated by lifting the lever head.
Swivel to the left = hot water,
swivel to the right = cold water.
Technical Data
This mixer series-produced with
waterdimmer (flow limiter)
Rate of flow with waterdimmer:
Rate of flow without waterdimmer:
Operating pressure:
Recommended operating pressure:
Test pressure:
Hot water temperature:
Recommended hot water temp.:
Hansgrohe single lever mixers can be used together
with hydraulically and thermically controlled
continuous flow heaters if the flow pressure is at
least 1.5 bars.
If the continuous flow heater makes any problems or
there comes not enough water, the waterdimmer
(flow limiter 7a) located behind the mousseur must
be removed.
To adjust the hot water limiter on single lever mixers,
please see page 14.
No adjustment is necessary when using a
continuous flow water heater.
English

Spare parts

1
1.1 screw cover
2
3
4
5
6
7
8
8.1 diverter knob
8.2 pull rod
9
10 connection hose
XXX = Colors
000 chrome plated
090 chrome plated/gold plated
120 chrome plated/porcelain colour
150 chrome plated/wood
810 satinox
840 fine brass
7 l/min 3 bars

Special accessories

14 l/min 3 bars
max. 10 bars X
1 - 5 bars
16 bars
max. 80° C
65° C
handle
flange
nut
cartridge cpl.
locking screw
seal
aerator cpl. (10)
pop up rod
fixation set
®
special tool set
(not part of delivery)
17092X X X
96338000
94192X X X
94194000
92730000
96059000
95008000
13085000
92620X X X
94066X X X
94067X X X
96016000
95001X X X
58085000
7