Special Accessories - HANSGROHE Raindance Showerpipe serie Gebrauchsanleitung, Montageanleitung

Special accessories

(order as an extra)
tile-matching-disk Chrome Plated
#98681000 (see page 28)
Cleaning (see page 24)
Operation (see page 27)
Test certificate (see page 21)
Fault
Insufficient water
Crossflow, hot water being forced
into cold water pipe, or vice versa,
when mixer is closed
Spout temperature does not
correspond with temperature set
Temperature regulation not possible - thermo cartridge calcified
Instantaneous heater didn't work
with thermostat
English
Cause
- Supply pressure inadequate
- Regulator filter dirty #96922000
- filter insert shower dirty
- Backflow preventers dirty or
leaking
- Thermostat has not been adjusted
- Hot water temperature too low
- Filters are dirty
- check valve hasn't moved back
- Flow limiter in handshower isn't
removed
Assembly (see page 14)
Remedy
- Check water pressure (If a pump
has been installed check to see if
the pump is working).
- Clean filter in front of the mixer
and on the MTC-thermo cartridge
- Clean filter insert between shower
and hose
- Clean backflow preventers,
exchange if necessary
- Adjust thermostat
- Increase hot water temperature to
42 ºC to 65 ºC
- Exchange thermo cartridge
- Clean the filter / exchange filter
- Exchange check valves
- Remove flow limiter
5