Operation; Special Accessories - HANSGROHE Talis C 33102000 Montageanleitung

Attention! The fitting must be installed,
flushed and tested after the valid norms.
Assembly
1. Flush through the supply pipes.
2. Place the mixer including the sealing washer in
position on the basin.
3. Slip the fixation piece including the washer
over the threaded pin and tighten the nut.
4. Connect the supply pipes to the angle valves;
cold right - hot left.
5. Connect the pull rod to the pop-up waste.
Large differences in pressure between the hot and
cold water supply must be balanced.

Operation

The mixer is activated by lifting the lever handle.
Move to the left = hot water,
move to the right = cold water.
Technical Data
This mixer series-produced with waterdim-
mer (flow limiter)
Rate of flow with waterdimmer:
Rate of flow without waterdimmer:
bars
Operating pressure:
Recommended operating pressure:
Test pressure:
Hot water temperature:
Recommended hot water temp.:
6
English
Hansgrohe single lever mixers can be used
together with hydraulically and thermically con-
trolled continuous flow heaters if the flow pres-
sure is at least 1.5 bars.
If the continuous flow heater makes any prob-
lems or there comes not enough water, the flow
limiter (6a) located behind the mousseur must be
removed.
To adjust the hot water limiter on single lever mix-
ers, please see page 13.
No adjustment is necessary when using a con-
tinuous flow water heater.
Spare parts (see page 3)
1
1.1 screw cover
2
3
4
5
6
7
8
9
7 l/min 3 bars
10 locking screw for handle
14l/min 3
11 ball joint
max. 10 bars

Special accessories

1 - 5 bars
X
16 bars
max. 80° C
65° C
handle
flange
nut
cartridge, assy
seal
aerator cpl.
fixing set
supply pipe 450 mm
pull rod
special tool set
(not part of delivery)
33092000
96338000
94192000
94194000
92730000
95008000
13912000
96016000
96639000
96657000
96059000
92036000
58085000