Spare Parts; Special Accessories - HANSGROHE AXOR Terrano 37030 Serie Montageanleitung

Assembly
1. Flush through the supply pipes.
2. Place the mixer including the sealing washer in
position on the basin / bidet.
3. Push connection piece over the tails and tighten
with nut.
4. Connect the connection hose to the angle
valves; cold right - hot left.
5. Connect the pull rod to the pop-up waste.
Large differences in pressure between the hot and cold
water supply should be balanced.
Technical Data
This mixer series-produced with
waterdimmer (flow limiter)
Rate of flow with waterdimmer:
Rate of flow without waterdimmer:
Operating pressure:
Recommended operating pressure:
Test pressure:
Hot water temperature:
Recommended hot water temp.:
Hansgrohe two handle mixers can be used together
with hydraulically and thermically controlled continuous
flow heaters if the flow pressure is at least 1.5 bars.
If the continuous flow heater makes any problems or
there comes not enough water, the waterdimmer (flow
limiter 4a) located behind the mousseur must be
removed.
6
English

Spare parts

1
2
3
4
5
6
7
8
9
10 spout for bidet
11 aerator cpl.

Special accessories

X
7 l/min 3 bars
XXX = Colors
14 l/min 3 bars
max. 10 bars
000 chrome plated
1 - 5 bars
810 satinox
16 bars
max. 80° C
65° C
handle
screw cover, cold/ hot
spout large model
aerator cpl.
ELASTOP stop unit
pull rod
fixation set
connection hose
spout small model
special tool set
(not part of delivery)
®
37299X X X
96481X X X
96521X X X
94010X X X
94149000
94006X X X
96016000
96321000
96523X X X
96522X X X
94005X X X
58085000