Precautions; Description Of The Appliance; Safety And Control Devices; Identification - Riello TOP MODULANTE Bedienungsanleitung

2 PRECAUTIONS

The operation of any appliance that uses electrical power de-
mands that a number of fundamental safety precautions be re-
spected. In particular:
0
Never attempt to install the system without using suitable
personal protection equipment and without following all
applicable occupational safety standards.
0
It is forbidden to touch the device while barefoot or with
wet or moist body parts.
0
It is forbidden to perform any technical or cleaning opera-
tions before having disconnected the device from its elec-
trical power supply, by setting the system's main switch to
"off".
0
It is forbidden to pull, detach, or twist the electrical cables
protruding from the device, even if it is disconnected from
its electrical power supply.
0
Do not expose the storage cylinder to the elements. It is not
designed for use outdoors.
0
If solar plant pressure decreases, it is forbidden to top up
with only water as there is a danger of freezing and over-
heating.
0
Do not use connections or safety devices or fittings (expan-
sion vessels, pipes, insulation) that are not specifically de-
signed and tested for use in solar water heating systems.
0
Do not allow children or infirm persons to operate the sys-
tem unsupervised.
0
Do not dispose of packaging material into the environment,
or leave it within the reach of children, since it can become
a potential hazard. Dispose of packaging material in com-
pliance with applicable legislation.

3 DESCRIPTION OF THE APPLIANCE

The solar station TOP MODULANTE allows transferring sun power
from collectors to a storage system.
The solar station is enclosed in an EPP (Polypropylene foam)
insulating casing and is designed to perform:
− system flushing
− system filling and emptying
− circulator removal.
The key components are:
− high-efficiency circulator with variable speed
− shut-off valves as non-return valves
− thermometers
− pressure gauge
− fitting for connection to a solar expansion tank
− suitable safety device, as indicated in paragraph "Safety
and control devices".

4 SAFETY AND CONTROL DEVICES

Solar station safety and setting are achieved thanks to:
− Safety valve with trigger pressure set at 10 bar;

5 IDENTIFICATION

The solar stations by can be identified by:
Serial number plate
This specifies the serial number and model.
Cod. :
Serial N.° :
Mod. :
IP
MAX W
9
If these plates or any other means of clearly identifying
the product are defaced, removed or lost, proper instal-
lation and servicing may be rendered difficult.
In case of loss, request a duplicate to Technical Assistance Cen-
tre.
13 13
TqelNE100
Made in Italy